Hydrothermal Power plant

Hello.

The Hydrothermal engine at ambient temperature is a new concept not developed, a vapor, charges the pressured liquid, to generate powers, which were usually its. I think that some things are not done by converting any defined temperature loss into mechanical movement, which is economically solvent.

So we are entering a new era where all energy can be free everywhere and at any time, without storage or infrastructure. 

The needed power for the vapor to pressure water, oil, and any other liquid; somehow is much less than the energy generated by the turbine with the pressured fluid. (Have to be validated experimentally.)

With that, finished: The heat loss in the exhaust and cooling of thermal engines, and condensing process for steam turbines, and the multiples induced pollutions.

Energy, clean, sustainable, cheap, abundant, unlimited autonomy, available almost everywhere, almost free, works 24 hours in, 365 days, in which storage, infrastructure, is not necessary would change everything. Shall we change everything!

 Main components:

The used liquid can be Water, R404A, Ammonia, and Propane. Alternatively, any other legal appropriate to this task.

 Heat input (1 ), Boiler(2), Pressurized water/ liquid containers (3) &(4), liquid pump (5), Steam/vapor valves (6) & (7), Water/liquid valves (8) & (10), Water/liquid turbine (9), liquid detector (a)(b) (c)(d), One way liquid valves (f g). (To be connected)

Containers (2) (3) (4) have to support pressure, conformance with the application's security might be from 8 to 70 Bars (116 to 1015 psi) + Legal precaution.

Therefore, at a temperature of 20 ° C. Pressure of 11 Bars (160 psi.) Output power is equal to a dam of 105.6 meters (327 feet.)

 If we raise the temperature, to 50 C. (122 ° F.) we obtain 23 Bars (333.6 psi.) An output power equal to a dam of 221 meters (750 feet.)

Aucun texte alternatif pour cette image

Works:

The liquid is destined to generate hot saturated vapor. might be identical, similar, or different than the one intends to run the hydraulic turbine; the hardware elements must be inconsequently. 

The process starts by heating the circuit (1) using any method that has a higher temperature than ambient temperature, the high-pressure vapor, acts on the fluid to run the turbine (9) to generate power, which might be converted into electricity.

 The high pressured liquid available at the input of the Turbine (9), will lose some of its calories at the depressurized output side, which generates a temperature drop, somehow is equal to the calories converted mechanical motion; the temperature drop has to be restored by any heat available in around. The temperature drops are validated experimentally!

Costs: Manufacturing cost, much less than any Diesel or gasoline engine. Fuel-free.

#electricity #water #sustainable #energy #infrastructure